Experimenting with your walls is definitely a big deal! The emotional connection with your house compels you to keep making it bigger and better, maybe by trying out something by yourself or by experimenting but sans a plasterer.
The plastering work is one of the major initial parts when it comes to starting something new in your house. No matter how perfect it looks in the end, plastering does demand a lot of effort. A plasterer may give you an affordable estimation of the whole work but even then, if you want to do it by yourself, make sure you do your homework well before starting the work. One must have a proper understanding of the whole procedure.
For a better understanding, you must consult plasterer contractor who is well- experienced in this field. As a precautionary measure, it is best to follow a few steps as laid down by an expert plasterer. These tips will not only help you have a closer look at the whole procedure but will also guide you through steps to change the look of your house for better.
Tips to Guide You Through It Smoothly!
- Make the surface ready by peeling off the previous plaster. Clean it up by scratching it to an extent that no more plaster is s left. Also, clean dust or any poster sticks.
- Check if there is any suction on the wall. This suction is capable of sucking in the moisture from the plaster before it even dries up. The solution to this problem lies in throwing water on it. This helps in getting rid of suction. The walls that have low suction backgrounds, such as painted ones, also need to be properly prepared beforehand.
- Going ahead, you must add some bonding agent, such as PVA glue and water, so that the plaster sticks to the wall. A handful of the sand mix with PVA mixture will provide a rough texture.
- While mixing the plaster with water, mix it in the ratio of half and a half. Make sure that the water is clear. While mixing the water with plaster, ensure that no lumps are formed during the process.
- When you plaster a room, make sure to not to choose any two walls that are touching each other, as it may damage the other wall. Also, try to keep the temperature of your room cool.
- Since you are doing it on your own, start on a small area first to ascertain if you are getting the technique right or not.
- Giving a proper finishing to the plastered walls is the next major step.
- A combination of confident firm pressure and the correct angle of your trowel ensure a good plaster finish.
- You, probably, will not get the perfect surface in the first coat. But, not to worry, it takes time to dry. Following which, you may even spot a few imperfections here and there.
- After the first two coats, fill up the remaining holes in order to make the wall smooth and shiny.
- Be sure that the plaster is pliable enough to push the plaster into the holes. At the same, it should not be so wet that it forms new holes.
So, that’s about it! Not too difficult, isn’t it? All you need is little mindfulness and patience. Carrying out this little experiment on a small area will give you the confidence of trying it on the larger area as well.